Software design

/Software design


, , , ,

RxPense®* is a personal medication dispensing and remote monitoring solution that ensures Seniors and Chronic Care Patients at home (or elsewhere), take the correct medications on time and notifies caregivers if they miss a dose. It can also capture (though external sensors ), monitor and store vitals along with the electronic patient record for better […]

Polyurethane injection system for podiatric orthosis

, , , ,

The system consists of an Android application that communicates via Bluetooth to the standing station to get the most balanced position of the patient in order to determine the pressure points and to produce the most comfortable podiatric orthosis using an advanced Polyurethane injection system. The orthotist has the possibility to customize the orthosis by […]

Programming Test Jig

To avoid delivery delays of electronic products, it often happens that the firmware is not final during assembly. Pre programming microcontrollers is a good choice in terms of time and cost. However, this means that we should have a final version of the software.

When there is a change of version of the embedded software of […]

Test jig for CAN communication module

This Test Jig tests the CAN, USB and UART communications.

It also performs many analog voltage reading to ensure that the assembly of electronic parts is performed.

A user interface allows to adapt the tests according to customer requirements. It also informs if the tests were successful and inform about the tests that did not pass.

“Bed of […]

Test jig for Wifi and Zigbee

This Test Jig validates the power of WiFi and ZigBee signals .

The detection module ensures the correct location to avoid serial number errors.

Light Indicators illustrate whether tests have passed and the units have issued the expected power.

A user interface allows you to view test results and what unit does not pass the tests.

Power Meter communicating […]

Production test jig for thermostat

This Test Jig validates the final product, so as to know whether the product has been put into housing.

This type of Test Jig comprises electronic components and electromechanical systems that can simulate human manipulation that normally interfere with the tested product.

It avoids human manipulation which may sometimes be inadequate or non-constant. It is programmed to […]

High-speed camera

, , , , , ,

This high resolution camera was developed for the microelectronic inspection industry. It can operate at up to 500fps with a higher resolution than HD (2368 x1728). It sends all its data through a high speed communication PCIe cable at speeds up to 40Gbps. Brioconcept was in charge of developing the electronic circuit, DSP firmware and […]

Battery and charger

, , , ,

This battery and charger was developed for the movies industry. the 126WH battery used C-LiFePO4 cells developed by l’IREQ. It also features a BMS and RFID for better battery tracking. Capable of delivering up to 20A, the battery can be charged in approximately 45 min.

Battery management
LCD Screen
Voltage and current monitoring

Drum machine

, , , ,

Brioconcept has developed the first guitar pedal drum machine. It plugs right in with your other pedals to play a drum beat through your amp. No mixer required! Hands free functionality: Add fills, transition from verse to chorus, add ‘one off’ accent hits (such as cymbal crashes or hand claps) all with a press of a […]

Personal locator

, , , , ,

This GPS watch serves as a personal locator that include advanced 3G/4G cellular technologies for rapid alerting and accurate GPS locating to within 10ft (3m).  Fall detection and Bluetooth connectivity are other features included in this waterproof locator.

Cellular communication
Bluetooth communication
GPS receiver
Rigid/Flex PCB