The system consists of an Android application that communicates via Bluetooth to the standing station to get the most balanced position of the patient in order to determine the pressure points and to produce the most comfortable podiatric orthosis using an advanced Polyurethane injection system. The orthotist has the possibility to customize the orthosis by […]
To avoid delivery delays of electronic products, it often happens that the firmware is not final during assembly. Pre programming microcontrollers is a good choice in terms of time and cost. However, this means that we should have a final version of the software.
When there is a change of version of the embedded software of […]
This Test Jig tests the CAN, USB and UART communications.
It also performs many analog voltage reading to ensure that the assembly of electronic parts is performed.
A user interface allows to adapt the tests according to customer requirements. It also informs if the tests were successful and inform about the tests that did not pass.
“Bed of […]
This Test Jig validates the power of WiFi and ZigBee signals .
The detection module ensures the correct location to avoid serial number errors.
Light Indicators illustrate whether tests have passed and the units have issued the expected power.
A user interface allows you to view test results and what unit does not pass the tests.
Power Meter communicating […]
This Test Jig validates the final product, so as to know whether the product has been put into housing.
This type of Test Jig comprises electronic components and electromechanical systems that can simulate human manipulation that normally interfere with the tested product.
It avoids human manipulation which may sometimes be inadequate or non-constant. It is programmed to […]
FPGA design, Hardware design, Mechanical design, PCB Layout, Realizations, Simulation, Software designbrio_admin
This high resolution camera was developed for the microelectronic inspection industry. It can operate at up to 500fps with a higher resolution than HD (2368 x1728). It sends all its data through a high speed communication PCIe cable at speeds up to 40Gbps. Brioconcept was in charge of developing the electronic circuit, DSP firmware and […]
This battery and charger was developed for the movies industry. the 126WH battery used C-LiFePO4 cells developed by l’IREQ. It also features a BMS and RFID for better battery tracking. Capable of delivering up to 20A, the battery can be charged in approximately 45 min.
Voltage and current monitoring
Brioconcept has developed the first guitar pedal drum machine. It plugs right in with your other pedals to play a drum beat through your amp. No mixer required! Hands free functionality: Add fills, transition from verse to chorus, add ‘one off’ accent hits (such as cymbal crashes or hand claps) all with a press of a […]